Ford E-Series Swivel Seat Base Set

Wonderful and installed with no problems.

The Swivel seat base set arrived today and I installed them with no problems. It took approximate 2 hours to install. Thanks

Worked great, fit like a glove. Thank you

I ordered these and they arrived in a very timely manner. The two seat bases in a rather beat up box. Not your fault for that. How ever they weren't marked left or right and came with no instructions. Maybe I'm a bit thick but it took some study to finally figure them out. I work slow, so it took me about four hours it install them. They are a great addition to the RV! I would have given 5 stars if there had been instructions. If you pull both seats out to start,. instead of starting on the passenger side, it is more apparent which goes where. Also the plastic ( rubber) floor mat gives the impression that the floor undulates and that the flat seat base will not work, cut the plastic and remove the sound deadening fabric underneath and low the floor pan is indeed flat.

Very easy to install and works perfectly.

This could have been 5 stars but I started installing my driver’s side seat base and couldn’t get it to seat in the bracket. I measured the hole spacing and their was a 1/4” difference between the 2 sides everything was painted nicely. After a bunch of aggravating measurements and pictures I was ready to email and call to get a replacement.
The situation was resolved with a call to Sportsmobile after more measurements I found I was able to loosen a bolt which allowed for micro adjustments on the base.
If instructions were placed inside OR the holes were spaced correctly I would’ve been saved some aggravation.
The seat base works great for my class c e350 which didn’t have a swivel base and I have opted to retain the factory passenger base which angles away from the door and wall allowing more space.
It’s an awesome upgrade if your seats don’t swivel. You will need an extension for electrical wires to spin the seat

Fit amazingly and I have a 4x4 Quigley and all I did was cut the stick off at the base and is no held by a coupler and bolts if needed. I leave the stick off at all times unless off-road